Daily maintenance and practical small dry goods

Release time:

2021-05-18

As we all know, the service life of a machining center is closely related to daily maintenance and maintenance! If you don't want to cause accidental wear and tear of the machining center due to dust accumulation on the radiator dust screen, damage to the circuit assembly by unknown objects, etc., then continue to look down!

As we all know, the service life of a machining center is closely related to daily maintenance and maintenance!

If you don't want to cause accidental wear and tear of the machining center due to dust accumulation on the radiator dust screen, damage to the circuit assembly by unknown objects, etc., then continue to look down!

01、Daily maintenance

02、Daily maintenance rules

03, cooling system

Pneumatic system

01、Daily maintenance rules

Daily maintenance rules are one of the necessary rules for every machining center. However, there are still many users who ignore it for various reasons. Perhaps ""not paying attention to"" is the most critical reason, or maybe not aware that routine maintenance will prolong the service life of the machining center.

A daily maintenance code will be pasted next to the safety door of every machining center in our company. Users only need to spend a minute to watch it carefully and follow it carefully, and they will get unexpected benefits!

Suggestion: Before operating the machine, the operator should read this daily maintenance code as much as possible and strictly follow it.

02, cooling system

Every machining center is basically equipped with a corresponding heat dissipation system, including heat exchangers and oil coolers. Its function is obvious, preventing the corresponding electrical components from overheating and cooling and dissipating heat.

Our company will also paste a copy of the precautions for cleaning the dust-proof net of the heat-dissipating system in the blank position of the dust-proof net of the heat-dissipating system.

Recommendation: Remove the dust screen and clean it at least once a week, and dry it after cleaning to avoid reduced cooling capacity and malfunctions.

03, pneumatic system

The three-point combination in the pneumatic system is also one of the main components of each machining center, and the three-point combination plays a role in filtering the air. If there are too many impurities in the air, it will further affect the use of the whole machine.

Each widget in the three-point combination will be printed with some precautions and usage methods, just check it carefully.

Recommendation: Perform three-point combined drainage work every week to avoid the air entering the filter cup