Relevant knowledge about the operation of CNC surface grinder
Release time:
2021-05-18
One type of grinder mainly uses the grinding wheel to rotate and grind the workpiece to achieve the required flatness. According to the shape of the worktable, it can be divided into two types: rectangular worktable and round worktable. The main parameter of the rectangular worktable surface grinder is the worktable width. And the length, the main parameter of the round table surface grinder is the table diameter. According to the different types of shafts, it can be divided into horizontal shaft and vertical shaft grinders.
One type of grinder mainly uses the grinding wheel to rotate and grind the workpiece to achieve the required flatness. According to the shape of the worktable, it can be divided into two types: rectangular worktable and round worktable. The main parameter of the rectangular worktable surface grinder is the worktable width. And the length, the main parameter of the round table surface grinder is the table diameter. According to the different types of shafts, it can be divided into horizontal shaft and vertical shaft grinders.
Surface grinder operation instructions
1: Surface grinder positioning
The machine tool should reserve more than 300mm outside the maximum movement space, each foot screw should be tight, and the front, back and left and right levels of the table should be within 0.04/1000mm. (The requirements for installing the inverter need to be higher)
Inspect every three months, adjust the level of the work surface, and tighten each foot screw.
2: Surface grinder wheel
The selected grinding wheel must be able to withstand a rotation speed of more than 2000m/min.
It is forbidden to use damaged grinding wheels.
The flange of the new grinding wheel must be balanced.
Before the formal grinding, the grinding wheel should be idling for 5 minutes.
The maximum feed stroke is 0.03mm for grinders below 800mm, and 0.05mm for grinders above 800mm
3: Surface grinder spindle
Before installing the grinding wheel, make sure that the spindle rotates clockwise.
When starting up, the spindle must be turned on first and then the flushing must be started.
4: Hydraulic device for surface grinder
The surface grinder uses hydraulic oil with a viscosity of No. 46.
The hydraulic oil needs to be replaced after three months of use for the new machine, and then once a year in the future, and the oil tank must be cleaned at the same time.
Check the hydraulic oil level every day. The oil level should be between the lowest and highest line.
Before starting the hydraulic motor, make sure that the flow speed control lever is in the closed position.
The magnetic attraction must be turned on first and then the hydraulic pressure must be turned on
5: Surface grinder lubrication device
The lubricating oil uses the guideway lubricating oil with a viscosity of 32. (Recommend Mevista No. 1 or No. 1405)
Confirm the oil volume of the oil tank (pool) every day to ensure that it is above the offline.
Check whether the guide rail oil circuit is unblocked every week to prevent the guide rail from losing oil.
It is recommended to clean the fuel tank every three months.
Grease should be filled regularly as required.
6: Left and right mechanism of surface grinder
It is forbidden to adjust the left and right stroke when the workbench is moving.
When the workbench cable becomes loose, it should be adjusted immediately. (This article applies to manual models)
7: Surface grinder flushing and dust suction device
The filter of the vacuum box must be cleaned once every two weeks.
The cold water tank must be cleaned once a month.
It is forbidden to use an air gun to clean the surface grinder.
RELATED NEWS
Crossbar machine tool
Mobile QR code
Nantong Zongheng Machinery Co, Ltd
TEL
ADDRESS
No.58 Jiangtong Road, Henggang community, Xingren Town, Tongzhou District, Nantong City, Jiangsu Province